Tarpaulin manufacturers remind truck tarpaulin installation precautions

       When trucks are driving, especially on highways, they cannot stop casually. Therefore, truck tarpaulins are required when consigning goods. However, how to tie tarpaulins is a technical task, which is related to the safety of driving, so everyone needs to be extra special. Attention.

       The cargo loading height is more than 1m above the end side wall or the gondola with the escort shall not be covered with tarpaulin. Tarpaulins and tarpaulin rope nets shall not be used as cargo reinforcement materials. Therefore, the goods that need to be reinforced must be bundled and reinforced before the tarpaulin is covered. There are no residues of old rope ends, iron wires and other wastes on the truck ropes.

1. When the cargo loading height is lower than the side wall of the vehicle end, the tarpaulin bracket can be installed, and the protruding part of the bracket and the tarpaulin should take anti-wear measures. When the cover is easy to damage the tarpaulin, anti-wear or protective measures should be taken between the tarpaulin and the cargo.

2. Avoid collisions with sharp metal openings during use. Especially for new tarpaulins, try to cover the bottom with old cloth for proper protection to prevent the wear of the tarpaulin caused by the carriage iron.

3. The tarpaulin cover is flat and no cargo is exposed. The top is ridged, and the two ends wrap the corners tightly, and the size of each part does not exceed the limit.

4. The cloth body is complete without damage, the eye circles are intact, the markings and numbers are complete and clear, the ropes are complete, complete, without joints, firmly inserted, and correctly connected to the tarp.

5. The rope is tied and tied at the correct position, the rope is tight, the force is even, and there is no slack off, to prevent local cracks in the tarp when the vehicle is driving at high speed. The rope tied to the rope has a butterfly-wing knot, and the length of the rope head and tail is 10~30cm.

6. The sagging height of the tarpaulin on both sides of the truck should be the same. The tarpaulin at one end of the truck manpower brake machine is drooping to cover the height of the end wall from 300mm to 500mm, and the other end is drooping to cover the height of the end wall about 600mm.

7. Tighten the corner rope of the tarp so that the corner of the tarp is unfolded into a triangle inward. The corners of the tarpaulin are flattened on both sides and folded to the end wall of the truck.

8. The tarp on both sides of the vehicle has the same drooping height, the lines on both sides are smooth, the rear side is flat and tightened, and the vehicle number is exposed.