Tarpaulin manufacturers share truck tarpaulin installation experience

1. The pressure ropes at each end of the tarp should be pressed against the corners of the tarp and tightened so that the tarp is tightly attached to the end wall of the vehicle and tied to the first ropes on the sides of the vehicle. They must not be tied to the traction hook.

2. The place where the truck is tied to the rope should not be tied to other parts. The tarp rope should be turned into the word "again" and then tied to the other end of the rope end. Fold the rope into two, and then tie it into a turnaround flower. In other words, the rope tethering adopts the bow tie method or the back-to-head knot method. After the tethered rope, it should be wrapped around its own rope pole, and at least two dead knots should be tied. The length of the rope head and tail shall not exceed 300mm and not less than 100mm.

3. The waist rope should be tied straight to the side rope of the car. The stretched length of the elastic part of the bungee cord shall not be less than 200mm, which shall be determined according to the cargo loading. If there is a rope in the middle of the vehicle, the waist rope in the middle is tied to the rope in the middle of the vehicle; if there is no rope in the middle of the vehicle, the waist rope in the middle of the tarp is tied to the rope near the middle of the vehicle. Other waist ropes, starting from the two ends of the vehicle, toward the middle of the vehicle, are tied to the corresponding ropes in sequence. When the elastic rod is not close to the eye circle, the elastic rope should be retracted from the middle, and the excess rope in the middle should be folded and tied into two knots.

4. Except for the tarp's own rope and tarp rope net, other ropes shall not be used to bind the tarp. When the remaining rope is long, it must be stuck, and the rope should not be allowed to be arbitrary.

5. The bundled plastic tarpaulin should be covered and flat as a whole, the cargo should not be exposed, the corners at both ends should be solid and dense, the lines should be smooth, each part should not exceed the limit, and should be firm and not loose or fall off. Of course, it is necessary to ensure that the truck hand brake disc is exposed.

6. The tarpaulin corner ropes at both ends of the truck are crossed along the end wall of the truck and tied to the two ropes at the ends of the truck respectively. When the angle rope passes through the brake platform of the truck's human brake, it should pass through it; when it passes through the brake rod and the hook lever, it should pass through the inner side. At the same time, pay attention to the two end ropes in the middle of the tarpaulin at both ends of the truck. Pull down vertically and tighten the two ropes tied to the ends of the vehicle. When passing through the hook rod, they should also pass through the inner side.